X500pro
3D printer manual
DRAFT
German
RepRap
10.2 Printer Commands - Overview
Filament Feed In
This commands are used to feed in the filament after inserting a new filament or a change of a filament.
EXT0 and EXT1 represent the equivalemt extruder position for the filament. HYDREL is the representative
for a soft filament (which requires a special process for feeding in).
Jam Debug Mode ON
Enables the debug mode for the filament tracking sensors. After enabling, you can see the tracking sensor
output in the console window.
Jam Debug Mode OFF
Disables the jam debug mode for the filament tracking sensors.
Measure & Store Z-Length
The printer will home and measure 3 coordinates on the buildplate. It will store the measured length of the
Z-axis in EEPROM.
The printer will home again to indicate a successful finished routine.
Home Extruder Swing Motor
This will reset the motor resaponsible for the extruder swing posiiton.
Position Head&Bed and Levelling xxx
Position the bed and the head to for adjusting axis
Important:
The extruder needs to be heated to the right temperature of the filament type.
Important:
Please deactivate all software correction methods
before manual levelling.
->Disable all corrections
Leveling positions 1-5
This will move the tool head to the right positions
for manual levelling.
Go through all positions twice and level the build-
plate using the screws underneath. The readout of
the laser sensor should be the same (±0,05) on all
positions.
66/83
