Manualedelleistruzioni per l’uso
Document code
Pag.
di
Rev.
SAVE DATA
PRINT DATA
03-09-12_UIMG2 Manual ENG
11
18
00
23/07/13
23/07/13
7.6.4. REMOVING THE TIRE/WHEEL ASSEMBLY
Tools Required
: 13mm socket wrench
To remove the Tire/Wheel assembly:
1. Extract the LeanSteer frame
2. Tip the machine onto its side so the Wheel you want
to remove is facing up, and the other Wheel rests
against a clean, smooth surface.
3. Remove the Wheel Cap by pressing down on the
outside edge, and lifting the opposite outside edge
with your fingers or a plastic wedge.
4. Remove the 3 Wheel Nuts with a 13mm socket
wrench. Hold the Wheel to keep it from rotating.
5. Lift off the Wheel.
6.
Clean all debris from the Wheel’s mounting surfaces.
7. Put the machine back in its original vertical position.
Tools Required
: 13mm socket, torque wrench
To install the Tire/Wheel assembly
1. Extract the LeanSteer frame
2. Tip the machine onto its side so the Wheel you want
to remove is facing up, and the other Wheel rests
against a clean, smooth surface, making sure to put
a pad or something thick between wheel and floor to
avoid scraping of the fairing against to floor.
3.
Clean all debris from the Wheel’s mounting surfaces.
4. Place the Tire/Wheel assembly over the 3 threaded
posts.
5. Hold the Wheel to prevent it from rotating.
6. Thread on the 3 Wheel Nuts, and tighten to 35 N-m
(26 ft-lbf) with a 13mm socket.
7. Replace the Wheel Cap by aligning the three plastic
fittings on the underside of the Wheel Cap with the 3
holes in the Wheel.
8. Press down until the Wheel Cap snaps into place.
9. Put the machine back in its original vertical position.
