Manualedelleistruzioni per l’uso
Document code
Pag.
di
Rev.
SAVE DATA
PRINT DATA
03-09-12_UIMG2 Manual ENG
8
18
00
23/07/13
23/07/13
7.6. REPLACING PARTS
Power off Genny 2.0 and disconnect the power cord from the AC power outlet prior to any
maintenance intervention.
7.6.1. REMOVING/ATTACHING THE HANDLEBAR
Tool Required
: 3mm hex wrench.
To remove the Handlebar from the LeanSteer Frame:
1. Make sure the machine is unplugged and powered
off.
2. Using the 3mm hex wrench, remove the 3 fasteners
that secure the Handlebar Clamp to the LeanSteer
Frame.
3. When you remove these fasteners and the Handlebar
Clamp, the Handlebar is released from the LeanSteer
Frame.
Tool Required
: Torque wrench with 3mm bit.
To attach the Handlebar to the LeanSteer Frame:
1. Make sure the machine is unplugged and
powered off.
2. Align the Handlebar in place against the
LeanSteer Frame using the alignment guides.
3. Position the Handlebar Clamp against the
Handlebar.
4. Insert the 3 fasteners through the Handlebar
Clamp into the LeanSteer Frame.
5. Using the 3mm hex wrench, alternate between
the 3 fasteners, evenly tightening in small
increments until the full torque setting of 6.0 N-m
(4.4 ft-lbf) is achieved.
Check to ensure that the gap between the
Handlebar Clamp and the LeanSteer Frame is even,
and the same between the top and bottom.
