![background image](http://html1.mh-extra.com/html/genius/ge-nutri/ge-nutri_user-manual_2212730012.webp)
GE-NUTRI INSTALLATION
Section B-12
GE-NUTRI
General installation guidelines
GE-NUTRI Controller
-
It is recommended to install the unit in a hallway to limit the GE-NUTRI
Controller exposure to noxious gases.
-
In order to avoid condensation problems inside the controller, it is
recommended to install the GE-NUTRI Controller on an inside wall. If it is not
possible, use spacers to have an air gap between the wall and the GE-NUTRI
Controller.
-
It is required to install the GE-NUTRI Controller right side up with the cable
entry holes facing down.
-
The enclosure is watertight, but do not spray water or submerge the GE-
NUTRI Controller in water. Cover it carefully with plastic when cleaning the
room.
-
The GE-NUTRI Controller should be installed in easy-access location but
away from damaging elements (heat, cold, water, direct sunlight, …).
-
Do not drill the face, the side, the top or the underside of the control.
-
Do not install the GE-NUTRI Controller near high-voltage equipment, power
supply or transformer.
Electrical cables
-
All electrical cables must be installed according to local wiring codes.
-
All cable shields must be connected to the shield terminal on the cord to
which the cable is connected, except for the cable connected to the optional
PC interface. The shield is needed to protect the GE-NUTRI Controller and
the modules against any electromagnetic interference generated by lightning
or nearby operating machinery.
-
Never use the shield as a conductor.
-
Connect only one end of the shield to the GE-NUTRI Controller.
-
Use separate conduits for the low voltage cables (communication and probes)
and the high voltage cables. There must be at least 1 foot (30 cm) between
low-voltage and high-voltage conduits.
-
If a low voltage cable has to cross over a high voltage cable, make this
crossing at 90°.
-
All cable connections must be soldered or done with approved sealed
connectors.
-
Probe cables must be 500’ (150m) or less.
-
Communication cables must be 820’ (250m) or less.
-
It is prohibited to use overhead cables outside the building.
Electrical power
-
Protection from electrical surges should be included in the planning of each
installation.
-
Every module should have a separate breaker to avoid unwanted
consequences.
Summary of Contents for GE-NUTRI
