GE-NUTRI USER’S GUIDE
Section C-50
GE-NUTRI
MAIN MENU
CYCLES PROGRAM {1-4}
1.
This parameter is used to select the number of cycle used by a program.
There is a maximum of 10 cycles per program. There is always at least 1
used cycle in a program.
2.
These parameters are used to indicate the system if the corresponding cycle
is used or not. When a parameter is set to
"Yes"
, the program will used the
corresponding cycle. If this parameter is set to
"No"
, the cycle will not be
considered.
3.
These parameters are used to choose the cycle start times.
The cycles’
departure times must be in chronological order
.
4.
In multi-feed, feed auger and feed auger drop mode, these parameters are
used to select which feed type will be used for the corresponding cycle. The
feed augers associated to a feed type selected here will be active during the
corresponding cycle. In chain feeder and chain feeder drop mode, the feed
augers are directly selected by the user.
S e t t i n g s P r o g #
C y c l e Q u a n t i t y : 6
C y c l e s H o u r s F e e d
1 : Y e s 1 2 : 0 0 P - - - -
2 : Y e s 1 2 : 0 0 P - - - -
3 : Y e s 1 2 : 0 0 P - - - -
4 : Y e s 1 2 : 0 0 P - - - -
5 : Y e s 1 2 : 0 0 P - - - -
6 : Y e s 1 2 : 0 0 P - - - -
7 : Y e s 1 2 : 0 0 P - - - -
8 : Y e s 1 2 : 0 0 P - - - -
9 : Y e s 1 2 : 0 0 P - - - -
1 0 : Y e s 1 2 : 0 0 P - - - -
[3]
[1]
[2]
[4]
Summary of Contents for GE-NUTRI
