![background image](http://html1.mh-extra.com/html/genius/ge-nutri/ge-nutri_user-manual_2212730028.webp)
GE-NUTRI USER’S GUIDE
Section C-28
GE-NUTRI
-
The feed auger stops when the proximity switch indicates that the manger
is full for the filter’s end time.
-
The feeder continues for an adjustable delay until the end of the cycle.
In feed auger mode, the general sequence of a cycle operates as follows:
-
At the start time of a cycle, feed augers assigned to the cycle’s feed type
will activate.
-
The proximity switches assigned to feed augers do not check if there is
fee during their start filter.
-
Each feed auger stops when their corresponding proximity switch
indicates that the manger is full for the filter’s end time.
-
The cycle finish when all the feed augers stop.
In chain feeder drop mode, the general sequence of a cycle operates as
follows:
-
At the start time of a cycle, the actuators of the program conduct a closure
time, a time of waiting and an opening time. These delays are all
adjustable.
-
The feeder and the feed augers assigned to the cycle will activate..
-
The proximity switch does not check if there is feed during the start filter.
-
The feed auger stops when the proximity switch indicates that the manger
is full for the filter’s end time.
-
The feeder continues for an adjustable delay until the end of the cycle.
In feed auger drop mode, the general sequence of a cycle operates as
follows:
-
At the start time of a cycle, the actuators of the program conduct a closure
time, a time of waiting and an opening time. These delays are all
adjustable.
-
Feed augers assigned to the cycle’s feed type will activate.
-
The proximity switches assigned to feed augers do not check if there is
fee during their start filter.
-
Each feed auger stops when their corresponding proximity switch
indicates that the manger is full for the filter’s end time.
-
The cycle finish when all the feed augers stop.
Important details that must not be overlooked while using this controller:
-
If a cycle is not over when the starting time of another cycle is reached,
the system will finish the current cycle before starting the next one.
-
When the system is set to On, the system will not activate the past cycle.
-
When system is Off, the positioning will be 0%.
-
Only one cycle can pass through midnight. When this occurs, the current
cycle will finish normally, but the other cycles of the day will be ignored.
Summary of Contents for GE-NUTRI
