GE NetworX V3, Installation Manual

Page: 94 / 286

NetworX Version 3 Installation Manual
94
Location Term Definition
2.7.3.2 Closing/Autoarm A menu option that sets the time after which the partitions
selected in
Partitions Autoarming start to arm
automatically. Users with arm only after closing rights can
arm the partitions selected in
Partitions Opening only after
this time.
2.8 Reset Settings A menu entry that groups entries related to default panel
settings.
2.8.1 Country Code A menu option that sets a default country code for the
panel.
2.8.2 Reset Settings A menu option that resets all the control panel settings to
their factory defaults.
2.8.3 Switch to EN A menu option that switches the panel to the EN 50131-
compatible settings. For additional information about the
EN 50131 norm, see Appendix 7.
Control panel programming locations
Telephone number 1
LOCATION 0 - PHONE N° 1 (20 segments, numerical data)
The first telephone number is programmed in location 0. A “14” indicates the end of the phone
number. Delays of four seconds can be programmed at any point in the phone number by
programming a “13” in the appropriate segment. The system will always wait for a dial tone, unless
the first digit of the phone number is a “13”; in this case, it will only delay. Tone (DTMF) dialling is
default. If you want pulse tone dialling, program a “15” in the segment where pulse dialling should
begin. If the entire number should be pulse dialling, program a “15” in the first segment. Program an
“11” for a “*”, and a “12” for a “#”.
Note: A zero is programmed as a “0”.
LOCATION 1 - ACCOUNT CODE FOR PHONE N° 1 (6 segments, numerical data)
Location 1 is used to program the account code that is sent when phone N°1 is dialled. A zero in the
account code is programmed as a “0”. A “10” indicates the end of the account code, so program a
“10” in the segment immediately after the last digit of the account code. If the account code is 6
digits long, program all 6 segments.