GE NetworX V3, Installation Manual

Page: 176 / 286

NetworX Version 3 Installation Manual
176
3.
Select Del. RF Device>Del. RF Keypad , and then select the keypad number of the keypad
you want to delete ( RF Keypad 2 ) and press OK .
4.
The keypad number 2 is deleted, and all its programming information is removed from
memory.
Note: You cannot delete the currently used wireless keypad (the one used for programming).
Note: After deleting the wireless keypad, you have to default it to clear any existing settings. To do this, press
F1+6+Down Arrow simultaneously for a few seconds. The wireless keypad can only be brought back to
defaults (to initiate the startup process) if it is not in the range of an active NetworX V3 panel, i.e. the signal
strenght icon must show X.
Learning-in IO modules
In order to add a wireless siren or IO module to the system perform the following steps:
1.
Enter the programming mode on the keypad, navigate with the
½¾
keys to RF Receivers
and press OK .
Note: It is recommended to not learn any devices from a keypad which belongs to a partition different then Partition 1.
2.
Select the relevant module bus ID and press OK . For example, you can select RF
Receiver 32 , which is a built-in receiver on the NetworX V3 panel board.
3.
Select Learn RF Device>Learn Siren/IO , and then select the new siren/IO module
number ( Siren/IO 3 to 4 ) and press OK .
4.
Select Internal Siren and press OK .The panel starts the learning-in procedure, and the
Learn-in Mode message is displayed on the keypad(s).
5.
Power-up the IO module by connecting a battery pack or inserting batteries (consult the
device's manual for details).
6.
Wait until the LED on the IO module board blinks for 0.5 second.
7.
Trip the IO module tamper switch, simulating the closing of the housing for at least 0.5
second and maximum of 5 seconds, and release the tamper again.
8.
The LED on the IO module will blink for 1 second, ant the keypad beeps once to confirm
the module is programmed.
9.
The IO module is learned-in. Close the IO module housing.
Note: You can delete an IO module using the Del. RF Device menu option.
Learning-in wireless sirens
In order to add a wireless siren to the system perform the following steps:
1.
Enter the programming mode on the keypad, navigate with the
½¾
keys to RF Receivers
and press OK .
Note: It is recommended to not learn any devices from keypad which belongs to a partition different then Partition 1.
2.
Select the relevant module bus ID and press OK . For example, you can select RF
Receiver 32 , which is a built-in receiver on the NetworX V3 panel board.