GE NetworX V3, Installation Manual

Page: 222 / 286

NetworX Version 3 Installation Manual
222
Term Definition
Remote Initiated An Up/download setting that allows an upload/download session between the NX-7002 and the PC
to be initiated by the PC. The PC dials into the NX-7002. You must dial the data phone number to dial
into the GSM for upload/download. This setting is dependent on other settings (
Allow Calls From ,
Auto-answer and Callback Required ).
Report Attempts A Reporting menu entry that groups report options.
Report Control A block of reporting data that contains configurations to format selected events into one or more
messages according to pre-configured settings and send them to specified destinations.
A
Reporting menu entry that groups report control options.
Report Delay A Reporting setting that configures the delay in seconds before the NX-7002 module reports. If any
other events occur during this delay, they are sent with the first event in one message. This can be
from 0 to 255 seconds. This setting is valid only if using SMS reporting.
Report Format A Reporting setting that configures the communicator format used to report to the selected TCP/IP
receiver. Consult the instructions for your central station receiver to determine which format is
compatible.
Report Groups A Reporting option that sets which reports are sent to the phone number.
Report Timeout A Reporting setting that configures the maximum length of time for each attempt by the NX-7002 to
report to each receiver. If the report is not successful during this time, the attempt is abandoned. This
can be from 0 to 255 seconds.
Report When A Reporting setting that enables primary reporting ( Report Always ) or secondary reporting ( Panel
Dialer Problem ) for the selected report control.
See also Primary Reporting and Secondary Reporting
Report XSIA A Reporting setting that enables XSIA reporting. When this option is enabled, reports are sent in XSIA
format instead of SIA format. In short, it means that User/Zone names will be added to the reports. It
does not affect reports in any other format,.
Reporting A menu entry that groups reporting options for the GPRS module.
An
Options menu option that displays a status message when reporting is taking place.
Reset Settings
A menu option that defaults the GPRS module. This is a necessary procedure on all components
before starting to program the system.
RF Low Battery and
Restores A Reporting setting that sends a report to the selected report control when a low battery condition
occurs in an RF sensor. A restore report is also sent when the low battery condition is no longer
active.
RF Sensor Lost and
Restores A Reporting setting that sends a report to the selected report control when an RF sensor is missing. A
restore report is sent to the central station when the receiver receives a valid signal from the lost
transmitter.
RSSI Received Signal Strength Indicator. This indicates the field signal strength of the NX-7002.
RSSI in test call A Reporting menu entry that adds the RSSI strength into the test report.
RSSI Value Received Signal Strength Indication Value. This is a measure of the RF reception and is similar to the
indication on a mobile phone.
An
Options setting that displays the current RSSI value. The RSSI value is periodically updated when
logged into the network. RSSI values range from 0 to 31 with 99 as unknown.
S
Secondary reporting The means of reporting events that the control panel fails to report.
Sending SMS An Options menu option that indicates that the module is sending an SMS message over the GSM
network.
Serial Number An Options setting that displays the serial number of the GSM modem used by the NX-7002. It is used
for diagnostics only.