GE NetworX V3, Installation Manual

Page: 100 / 286

NetworX Version 3 Installation Manual
100
at the factory default of “0”. If you want dual or split reporting, and the split is based on partition,
then location 16 should be programmed to “0” and location 17 should be used to select those
partitions that are to be reported to phone N°3. If no events are to be reported to phone N°3, both
locations should be at “0”.
LOCATION 16 - EVENTS REPORTED TO PHONE N° 3 (2 segments, feature selection data)
Segment 1 1 = Alarms
2 = Opening and closings
3 = Zone bypass and bypass restores
4 = Zone trouble and trouble restores
5 = Power fail (AC failure), low battery, power restore (AC restore), and low
battery restore
6 = Bell cut, bell cut restore, telephone line restore
7 = Test reports
8 = Start and end programming, download complete and log full
Segment 2 1 = Zone and box tamper
2 = Auxiliary power overcurrent, and restore
3 = Wireless sensor missing and restore
4 = Wireless sensor low battery and restore
5 = Expander trouble and restore (keypads are considered as expanders)
6 = Fail to communicate
7 = Alarm restore
8 = Tamper restore
LOCATION 17 - PARTITIONS REPORTED TO PHONE N°3 (1 segment, feature selection data)
Location 17 is used when the events to be reported to a phone number are based on the partition,
regardless of the event. If this location is used, location 16 should be “0”.
Segment 1 1 = Partition 1
2 = Partition 2
3 = Partition 3
4 = Partition 4
Special formats
LOCATION 18 - CUSTOM COMMUNICATOR FORMAT (see locations 2, 8, and 14)
Segment 1
1 = On for 1800hz transmit; Off for 1900hz
2 = On for 2300hz handshake; Off for 1400hz
3 = On for checksum parity; Off for double round parity
4 = On for 2 digit event code; Off for 1 digit event code
5 = On for extended reporting; Off for non-extended reporting
6 = Reserved
7 = On for 20 PPS; Off for 10 or 40 PPS
8 = On for 10 PPS; Off for 20 or 40 PPS