NetworX Version 3 Installation Manual
60
2.
Navigate with the
½¾
keys to
Control Panel>Outputs>Internal Siren>Short Blast On
and press
OK
.
3.
Scroll to
Keyswitch Arming
>
Yes
and press
OK
.
4.
The keypad beeps once to confirm the change and returns to
Keyswitch Arming
.
Programming the keypad sounder
You can specify conditions and/or events that activate the keypad sounder. To configure the sounder,
you must enable the advanced menu. The following example programs the keypad sounder to
activate when an expander trouble condition occurs.
1.
Ensure the advanced menu is enabled.
2.
Navigate with the
½¾
keys to
Control Panel>Outputs>Keypads
>
Sound On
and press
OK
.
3.
Scroll to
Expander Trouble
>
Enabled
and press
OK
.
4.
The keypad beeps once to confirm the change and returns to
Expander Trouble
.
Assigning codes
Figure 17.
Installer codes menu
System codes can be either four or six digits long. This menu allows to program/change the installer
code and the duress code. A duress code disarms the system and activates a duress alarm. This is a
silent alarm that sends a special report to the central station. To program codes, select
Installer
Menu>Control Panel>Codes.
Note:
For EN/INCERT compliance, system access ID needs to be in 6 digit format.
Setting up the installer code
An installer code may have associated arming options and access rights. To set the authority and
access rights, you must enable the advanced menu. The following example assigns partitions 1 and 2
to a new installer code that can be used only to arm the system.
1.
Ensure the advanced menu is enabled.
2.
Navigate with the
½¾
keys to
Control Panel>Codes>Installer Code>Code
and press
OK
.
Duress Code
Guard Codes 16 17
User Auth for Progrm.
Code
Arm Only After Closing
Arm Only
Arm/Disarm
Master Code
Reports Open/Close
Bypass Zones
Installer Code
4/6 Digit Codes
Authority
2.3.1
2.3.2
2.3.2.1
2.3.2.2
2.3.2.2.1
2.3.2.2.2
2.3.2.2.3
2.3.2.2.4
2.3.2.2.5
2.3.2.2.6
Partitions
2.3.2.3
2.3.3
Summary of Contents for NetworX V3
Page 1: ...NetworX Version 3 Alarm System Installation Manual 1070138 ...
Page 10: ...NetworX Version 3 Installation Manual 10 Section A Installing and programming a basic system ...
Page 50: ...NetworX Version 3 Installation Manual 50 Section B Programming the system ...
Page 257: ...NetworX Version 3 Installation Manual 257 Section C References ...