GE NetworX V3, Installation Manual

Page: 31 / 286

NetworX Version 3 Installation Manual
31
Figure 10. Wired keypad connector block.
4.
At the panel side, run the NetworX bus wires through the ferrite (see Figure 11 ,
position
1
), making one loop, and connect the wires to the standard NetworX bus
contacts (see Figure 1 , position
4
). Additionally, connect the shielding to COM (see
Figure 11 , position
2
).
Figure 11. Panel connector block and the ferrite.
5.
Carefully close the keypad and tighten the 2 screws at the bottom side.
Note: Any opening of the keypad enclosure will cause tamper alarm in the system.
6.
Power up the panel. Select a language from the list with the
½¾
keys and press OK .
7.
Select default settings from the Load Country Defaults list with the
½¾
keys and press
OK .
8.
At the Partition Number prompt, type the partition number and press OK .
9.
At the Keypad Number prompt, type the keypad number and press OK .
1
2