GE Lullaby Warmer, Maintenance And Service Manual

Page: 50 / 165

24 2042376-001 Rev G ©2012 General Electric Company. All rights reserved. Lullaby
TM
Warmer
Important notes for consideration prior to cleaning:

Recommended cleaning cycle of the Lullaby TM Warmer is every one week or between
babies or following hospital guidelines.

Recommended cleaning cycle in addition to hospital guideline:
Between Patients:
•
Weekly for patients occupying the bed longer than one week
• When visible debris or discoloration is present

Wear a gown and gloves as per the hospital policy.

Prior to cleaning, remove any patient care equipment from drawers and shelves.
Remove any accessory equipment for cleaning as well as the patient temperature
probes.

Empty the drawers and the shelves. Remove the accessories and the probes.

Temperature probes must not be submerged in liquids. Discard the disposables. Use a
soft cloth to apply cleaning solution to the temperature probes to disinfect them.

These guidelines are designed to complement and are not meant to replace hospital
infection control policies.
Cleaning Instructions:
After each patient use, follow your hospital’s infection control procedures for surface disinfection.

Wipe down the surfaces of the Lullaby
TM
Warmer with a soft cloth dampened with a
cleaning solution. Refer to Section 3.6 Cleaning Solutions.

Always follow the cleaning solution manufacturer’s direction for use.

After completing air drying of cleaning solution, wipe all surfaces with a soft cloth to
remove any cleaner residue.
Illustration Description
Figure 43: The Hood
WARNING:-
Do not clean the radiant heating element inside the
protective grid.
WARNING: -
Do not spray cleaning solution into the vents on the
back of the heater assembly; this can damage the
electronic components inside the Lullaby
TM
Warmer.
CAUTION:-
Electronic devices are susceptible to damage from discharges of static electricity.
These devices are adequately protected, but can be damaged if the Lullaby
TM
Protective Grid
Heating Element