CS875-575-375-275-175 Installers Manual with CS5500 keypad
B.16.11
16.1.1.1.5.3.2
Aux Overcurrent and Restores
A menu option that sends a report to the selected phone number when too
much current is detected. A restore report is also sent when the overcurrent
condition is fixed.
16.1.1.1.5.4
Communications
A menu entry that groups together the communication events that are reported
to the selected phone number.
16.1.1.1.5.4.1
Fail to Communicate
A menu option that reports a fail to communicate event to the selected phone
number.
16.1.1.1.5.4.2
Test Reports
A menu option that sends a test report to the selected phone number at pre-
programmed intervals. The units can be set in days or hours.
16.1.1.1.5.5.1
Program/Download
A menu option that reports programming and up/download events to the
selected phone number.
16.1.1.1.5.5.2
Zone Inactivity Monitor
A menu option that sends a report to the selected phone number when a zone
inactivity event occurs.
16.1.2
Dial Attempts
A menu entry that groups dialling options.
16.1.2.1
ARC Dial Attempts
A menu option that specifies the number of dial attempts (1 to 15 attempts)
that the communicator makes when reporting to the selected phone number.
16.1.2.2
FTC Dial Attempts
A menu option that specifies the number of dial attempts that are made by the
GSM module to a specified phone number, before the Fail To Communicate
condition appears.
16.1.2.3
Voice/Siren Dial Attempts
A menu option that specifies the number of dial attempts (1 to 15) that the
communicator makes for voice dialing, pager or Siren Tone formats.
16.1.3
Burglary & Trouble Telim Ch
A menu option that specifies the TELIM channels to be used for burglary and
trouble reports.
16.1.3.1
When Disarmed
A menu option that specifies the burglary and trouble TELIM channel used to
report alarms while disarmed.
16.1.3.2
When Armed
A menu option that specifies the burglary and trouble TELIM channel used to
report alarms while armed.
16.1.4
Priority Reporting
A menu option that enables priority reporting.
16.1.5
Priority Type
A menu option that configures the priority type used when priority reporting is
enabled. If this option is set to Check Free B-Ch, the dialler disconnects calls
to report alarms by attempting to free the B-channel. If it cannot free the
channel, it disconnects the S0 bus.
If this is set to Always Disconnect, the dialler disconnects calls to report alarms
by disconnecting the S0 bus.
6.1.6
Backup Control
A menu option that configures the backup control for the GSM in SIA or CID or
configures the ISDN to be backup for the GSM .
16.2
Up/Download
A menu entry that groups options used to control download sessions between
the up/download software and the control panel.
16.2.1
Phone Number
A menu option that sets the phone number to which events are reported. The
control panel can report to up to six phone numbers.
16.2.2
Remote U/D When Armed
A menu option that allows an upload/download session between the module
and the PC to be initiated by the PC when the system is armed.
16.2.3
Answer Delay
A menu option that sets the number of seconds before the panel answers to
start an upload/download session.
16.3.1
ISDN
A menu entry that groups ISDN connection options.
Location
Term
Definition
