Page 59
X252 & X380 Engrave Settings
Note:
ONLY
These settings are to be used as a rough guideline
as each individual laser tube can vary.
Enhanced vector is a mode used commonly with
cutting thick pieces of material that cannot be
cut in the default vector mode. This mode will
slow the machine down by up to 50% enabling
the laser beam to cut more material. The side
effect to this mode is it will also slow down your
engraving speed.
Depending on a laser cutters age the firmware
in the machine can vary and some laser cutters
will be set up to use the enhanced vector mode.
To tell if your machine is set up with this mode
simply look for the enhanced vector box to be
checked in the Advance tab in the print properties
setting. (See Right)
Note:
If your enhanced vector box is ticked then all
you need to do when inputting your cut settings is
multiply your
by two.
cut settings only
Eg: If the chart recommends
2.0% Speed and 100% Power
on Enhanced vector the settings will be
4.0% Speed and 100% Power
Enhanced Vector Information
Speed
80
80
80
80
80
80
80
80
80
80
80
80
80w X252/X380
Power
25
Thin Card
65
15
35
100
15
15
20
15
15
35
35
PPI
400
400
400
400
400
400
400
400
400
400
400
400
Speed
80
80
80
80
80
80
80
80
80
80
80
80
100w X252/X380
Power
10
50
10
25
100
10
10
10
10
10
25
25
PPI
400
400
400
400
400
400
400
400
400
400
400
400
Boxcard
Lino
Cork
Glass
Correx
Leather
Fabric
Polypropylene
Laser Ply
Balsa Wood
Acrylic
