Page 5 - 28
Explorer 107 Operation and Maintenance Manual
Operations
© GBC Pro - Tech December 1999
f) Lift the table from the front and pull out away
from the laminator.
Lift from the front of table
Replacing the feed table
a) Lift the table from the front and set the rear
of the table into the rear feed table supprot
bolts.
b) Lower the front of the feed table into the
front feed table support bolts while pulling
the safety latches toward the center of the
feed table.
c) Latch the two safety latches of the feed table
into thier respective interlocks.
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
d) Pull the two locator latches of the pressure
plate toward the center and position the pins
with thier respective holes.
e) Pull both safety latches on the front safety
shield toward the center of the laminator
and lower.
f) Align the safety latches with thier respective
interlocks and slide the safety latches
outward.
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.