Page 6 - 7
Applications
Explorer 107 Operation and Maintenance Manual
© GBC Pro - Tech December 1999
INFORMATION
If not exactly centered, lateral film
adjustment can be made during the
webbing process.
l) Once the roll of film has been centered,, tighten
the thumb screws to sdecure in place.
m) For the bottom roll of film, follow the same
procedure just described.
Threading
W A R N I N G
The following steps are performed while
the laminator is HOT! Avoid contact
with the heating components!
a) Start with the upper roll of film. Unwrap about
2-3 feet ( 61-91 cm ) of film from the roll.
b) Pull the film under the rubber tension idler and
over the metal idler. Refer to Figure 6.1.1
Poly-in / Poly-out
Figure 6.1.1 Poly-in / Poly-out
Poly-in
Poly-in
Poly-out
Poly-out
c) Guide the film under the pivot bar of the front
safety shield and over the upper heating
components
