Page 1 - 6
Safety
Explorer 107 Operation and Maintenance Manual
© GBC Pro - Tech December 1999
W A R N I N G
If a safety feature is not functioning
properly, contact your local service
representative immediately
INFORMATION
When the laminator is first turned on, the
control panels display the default settings.
Default setting; Cooling Fan = Off, Motor
Speed = Off, Top Teflon Roller = 32
o
F, Nip
Rollers = 32
o
F, Bottom Teflon Roller = 32
o
F and Sub Heaters = 32
o
F.
INFORMATION
When any command is pressed ( with the
exception of Reverse ) on the Operations
Control Panel, a "beep" will sound. If the
command is held down, the panel will
continually "beep".
INFORMATION
Leave the motor speed adjust at 5 to
continue with the function check.
INFORMATION
Reverse speed can be controlled by
Speed Adjust.
INFORMATION
A second person is needed to assist with the
idler tension checks.
INFORMATION
Lower film tension idler: gray rubber
covered idler located below the lower
cooling fan assembly.
INFORMATION
Upper film tension idler: gray rubber
covered idler located above the upper
cooling fan assembly.
