Page 8 - 5
Maintenance
Explorer 107 Operation and Maintenance Manual
© GBC Pro - Tech December 1999
d) Use the 3M™ Scotchbrite™ pad to clean the
adheisive off of the top Teflon roller, the two
heat platens and the bottom teflon roller.
Teflon rollers
H
RA
UR
C
ON
RO
O
A
Heat platens
Nip rollers
e) Use the rubber cement eraser to clean the nip
rollers.
CAUTION
Excessive pressure can destroy the silicone
layer by pressing to hard or scrubbing
too long in one spot.
f) Replace the feed table and lower the front safety
shield.
INFORMATION
Locator latches on the pressure plate are
not associated with an interlock switch.
The laminator will operate without
the pressure plate installed.
g) Press
R E V E R S E
to move the bottom roller to
an unclean area and release.
M O T O R S P E E D
O F F
R E V R S E
1
2
3
4
5
6
7
8
9
10
Rollers only turn in reverse while
depressing .
INFORMATION
REVERSE
h) Repeat steps “a” through “g” until the adhsive is
beaded on the rollers.