Page 6 - 8
Applications
© GBC Pro - Tech December1999
Explorer 107 Operation and Maintenance Manual
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
W A R N I N G
d) Raise the front safety shield and remove the
pressure plate along with the feed table.
e) From the rear of the machine, unwrap about
2-3 feet ( 61-91 cm ) of film from the bottom
roll.
f) Pull the film over the rubber tension idler and
under the metal idler. Refer to Figure 6.1.1
Poly-in / Poly-out
g) Guide the bottom film up through the front of the
machine and overlap it with the film from the
upper roll of film.
h) Reinstall the feed table and lower the front
safety shield. Slide all safety latches into the
interlocks.
D A N G E R
At no time should you attempt to over ride
any of the safety latches on the laminator.
INFORMATION
The laminator will operate only when
all safety latches are in the fully
latched position.
i) Slide the threading card into the two overlapping
filmsand push into the nip rollers.
j) Lower the main roller and pull roller pressure
handles to the closed position.and press
O N
under MOTOR SPEED.
1
2
3
4
5
6
7
8
9
10
M O T O R S P E E D
O N
O F F
R E V E R S E