Garmin G1000 Series, Pilot'S Manual

Page: 68 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-40
PRIMARY FLIGHT DISPLAY
Figure 2-64 Approach
3. Turn the FMS knob to select the desired
approach, then press the ENT key. A window
appears listing the available transitions for the
approach.
Figure 2-65 Approach Transition
4. Turn the
FMS
knob to select the desired transi-
tion or vectors, then press the
ENT
key.
NOTE:
The ‘Vectors’ option assumes that the pilot
will receive vectors from ATC to the final course
segment of the approach.
Figure 2-66 Select Approach Window
5. With ‘LOAD?’ highlighted, press the ENT key
to load the approach.
6. To activate the approach, turn the large FMS
knob to highlight ‘ACTIVATE?’, then press the
ENT key.
NOTE: ‘LOAD’ adds the approach to the flight
plan without immediately using the approach
for navigation guidance. This allows the pilot to
continue navigating the original flight plan until
cleared for the approach, but keeps the approach
available for quick activation when needed.
‘ACTIVATE’ adds the approach to the flight plan
and begins navigating the approach course.
Select Arrival
Select Arrival allows the pilot to choose a published
standard terminal arrival route (STAR) for the destination
airport, or replace a current arrival with a new selection.
To select an arrival for a direct-to or flight
plan destination airport:
1. From an active flight plan, press the
PROC
key
to display the Procedures options window.
2. Turn the large FMS knob to highlight ‘Select
Arrival’, then press the
ENT
key. A window
appears listing the available arrivals for the
destination airport.
Figure 2-67 Arrival