Garmin G1000 Series, Pilot'S Manual

Page: 301 / 338

190-00592-00 Rev. A
Garmin G1000 Pilot’s Guide for the Diamond DA40
9-17
ANNUNCIATIONS & ALERTS
Miscellaneous Message Advisories (Cont.)
Alerts Window Message Comments
APPR VPROF – Approaching VNAV
profile.
Aircraft is approaching VNAV profile. Prepare to climb or descend to meet VNAV
profile.
APPR TRG ALT
– Approaching target
altitude.
Aircraft is approaching target altitude. Prepare to level aircraft.
LOCKED FPL
– Cannot navigate locked
flight plan.
This occurs when the pilot attempts to activate a stored flight plan that contains
locked waypoints. Remove locked waypoints from flight plan. Update flight plan
with current waypoint.
WPT ARRIVAL
– Arriving at waypoint
-[xxxx]
Arriving at waypoint [xxxx] where xxxx is the waypoint name.
STEEP TURN
– Steep turn ahead. A steep turn is 15 seconds ahead. Prepare to turn.
INSIDE ARSPC
– Inside airspace. Aircraft is inside airspace.
ARSPC AHEAD – Airspace ahead less
than 10 minutes.
Airspace is ahead of aircraft. Aircraft will penetrate airspace within 10 minutes.
ARSPC NEAR – Airspace near and
ahead.
Special use airspace is near and ahead of the aircraft position.
ARSPC NEAR
– Airspace near – less
than 2 nm.
Special use airspace is within 2 nm of the aircraft position.
LEG UNSMOOTH – Flight plan leg will
not be smooth.
The approaching flight plan waypoints are too close to make smooth turns. Prepare
for steep turns ahead and expect noticeable course deviations.
APPR INACTV – Approach is not
active.
The loaded approach is not active. Activate approach when required.
SLCT FREQ
– Select appropriate
frequency for approach.
Load the approach frequency for the appropriate NAV receiver. Select the correct
frequency for the approach.
SLCT NAV – Select NAV on CDI for
approach.
Set the CDI to the correct NAV receiver.
NO WGS84 WPT
– Non WGS 84
waypoint for navigation -[xxxx]
The selected waypoint [xxxx] does not use the WGS 84 datum. Cross-check position
with alternate navigation sources.
TRAFFIC FAIL
– Traffic device has
failed.
The traffic information system (TIS) has failed. The G1000 system should be serviced.
STRMSCP FAIL – Stormscope has
failed.
Stormscope has failed. The G1000 system should be serviced.
BACKUP PATH
– Stormscope using
backup data path.
Stormscope is using the backup communication path. The G1000 system should be
serviced when possible.