Garmin G1000 Series, Pilot'S Manual

Page: 48 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-20
PRIMARY FLIGHT DISPLAY
Radio Tuning Window (optional)
NOTE: The Radio Tuning window is only available
if the DME and/or ADF radios are installed.
The Radio Tuning window is displayed by pressing the
ADF/DME ( ADF , DME , or ADF/DME depending on the
installation) softkey. This window provides display and
control of single or dual ADF and DME radio(s). Depend-
ing on the installation, the Radio Tuning window may be
titled ADF Tuning, DME Tuning, or ADF/DME Tuning.
There are two ADF frequency fields, active (green) and
standby (white).
Figure 2-32 Radio Tuning Window
To edit the standby ADF frequency:
1. From the Radio Tuning window with the
standby ADF frequency highlighted, turn the
small FMS
knob to place the cursor on the first
digit.
2. Turn the FMS knobs to enter the desired fre-
quency and press the
ENT
key. The standby
frequency is now highlighted.
3. Press the
ENT
key again to transfer the standby
frequency to the active frequency field.
The ENT key is used to transfer the ADF standby and
active frequency whenever the cursor is highlighting a
standby frequency.
Any time the cursor is on the ADF standby frequency,
and the standby frequency is not in “edit” mode, the “ENT
TO TRANSFER” message is displayed at the bottom of the
Radio Tuning window to assist the pilot in performing the
transfer.
To change the ADF mode:
1. From the Radio Tuning window, turn the large
FMS
knob to highlight the ADF mode field.
2. Turn the
small FMS
knob in the direction of the
green arrow(s) to select the desired mode of
operation.
To change the ADF volume:
1. From the Radio Tuning window, turn the
large
FMS knob to highlight the volume field.
2. Turn the small FMS knob to the left to decrease
the volume. Turn the small FMS knob to the
right to increase the volume.
To change the DME mode:
1. From the Radio Tuning window, turn the large
FMS
knob to highlight the DME mode field.
2. Turn the small FMS knob to display the selec-
tion window. Turn the
FMS
knob to select the
desired mode and press the ENT key.
Figure 2-33 DME Selection Window