Page 2-8
G1000/GFC 700 Post Installation Checkout Procedure - Hawker / Beechcraft King Air C90
Revision 5
190-00682-00
6. Monitor load progress. Verify software load completes without errors as indicated by the following:
a. Green “PASS” in Configuration column.
b. “Upload Complete………….COMPLETE” in the summary box.
7. Select
PFD1
ENT
key to acknowledge upload complete.
2.5.3
Airframe Configuration Load Confirmation
1. Deselect cursor if selected, use the large FMS knob to select the GDU page group and the small
FMS knob to select “AIRFRAME CONFIGURATION” page.
2. Verify the correct airframe configuration, as loaded above, is displayed in the “IDENTIFICATION”
window.
If King Air C90 Baseline or King Air C90A — Config 3 was loaded above, verify the values listed in the
“AIRSPEEDS” window display 80 kts Vmca. For all other C90A configurations verify the values listed in
the “AIRSPEEDS” window display 90 kts Vmca. For the C90GT configuration, verify the values listed in
the “AIRSPEEDS” window display 85 kts Vmca.
2.5.4
Weight and Airspeed Configuration
In addition to the airframe configuration loaded above, certain installations will require additional steps to
configure the G1000 for airframe weight and airspeed markings
.
2.5.5
Determining the Correct Weight Configuration
If airframe configurations 4, 5, 7, 9 or 10 were loaded in step 2.5.2
•
Load weight configuration file King Air C90 – 05-206CGW if operating with Raisbeck AFMS 05-
206CGW , or
•
Load weight configuration file
King Air C90 – 90-206CGW if operating with Raisbeck AFMS 90-
206CGW
If airframe configurations 2 or 5 were loaded in step 2.5.2 and the aircraft serial numbers falls within LJ-
1063 through LJ-1137 or LJ-1146
•
Load weight configuration file King Air C90 – Weight LJ 1063-1137,
All other installations require no further weight configuration steps.
2.5.5.1
Loading Airframe Weight Configurations
Follow this procedure to enable the airframe weight configuration.
1. While in configuration mode and loader card inserted in the top card slot of PFD1, select the “System
Upload” page using the PFD1 small FMS knob.
2. Activate cursor in AIRFRAME window and rotate PFD1 FMS inner knob to display drop down menu.
Highlight “
C90-Weight and Airspeed
” and press
ENT
key
on PFD1.
