Galvanic Applied Sciences 943-TGS-CE, Operation Manual

Page: 132 / 158

Revision 5 132 August 2021
8. Mount the new spectrometer on the mounting bracket. It should be oriented with the
USB port and serial number label facing forward. Reinstall and tighten fully all mounting
screws.
9. Remove the protective cap from the detector fibre optic cable and connect it to the
SMA connector on the top of the spectrometer. The nut only needs to be tightened to
hand tight.
10. Connect the trickle purge line to the purge port on the spectrometer’s left side.
11. Connect the USB cable to the USB port on the front of the spectrometer.
Once the new spectrometer has been installed in the analyzer, it will be necessary to install the
new spectrometer calibration matrix file associated with the new spectrometer into the
analyzer. Follow the procedure below to update the spectrometer calibration matrix file.
1. Connect a laptop computer to the local Ethernet port. Ensure that the local Ethernet
connection displayed in the Config panel Network sub-panel displays as Active .
2. In a web browser program on the connected PC, enter in the IP address of the analyzer
followed by /Utility.html (for the local Ethernet port, this would be
http://192.9.200.16/Utility.html ) to access the Utility page shown in Figure 81.
Figure 81: Utility Page
3. Under the Calibration Matrix Upload to Analyzer heading, click on the Browse button.
Select the CSV format calibration matrix file with the file name indicated in the one-page
PDF document provided along with the spectrometer. The folder in which this file and the
calibration matrix will be found will have the spectrometer’s serial number (indicated on a
label on the front of the spectrometer) as the folder name. For an example, refer to Figure
82.