Galvanic Applied Sciences 943-TGS-CE, Operation Manual

Page: 133 / 158

Revision 5 133 August 2021
Figure 82: Spectrometer Calibration Matrix PDF Example
Select the file indicated by the Load File Named heading at the bottom right of this page,
then press OK. Once the file has been selected, click on Calibration Matrix Upload to
Analyzer to upload the file.
Uploading an incorrect calibration matrix file may render the analyzer
unusable. Be absolutely CERTAIN that the matrix file being uploaded is the
correct file. If uncertain, contact Galvanic Applied Sciences Inc. for
assistance.
4. Once the Calibration Matrix file has successfully uploaded to the analyzer, click on
Reboot
Analyzer to reboot the analzyer. The analyzer must be rebooted before it will start to use
the new calibration matrix file.
5. Once the analyzer has rebooted, navigate to the
Calibration Matrix
page in the web GUI
(refer to Section 5.2.2) and confirm that the first several rows of the displayed calibration
matrix match the first several rows of the calibration matrix printed in the PDF file supplied
with the spectrometer.
6. Navigate to the Factory Parameters section in the web GUI (refer to section 5.4). Switch
to Update mode, then change the Dark Start Pixel value to the Dark value indicated at
the bottom of the PDF file. Change the First Vector Pixel to the Start pixel indicated in
the PDF file. Once both parameters have been edited, click on Save to save the changes
to the analyzer.
Spectrometer
Serial Number –
Make sure this
matches
spectrometer
serial number
label!
Dark Start
Pixel and First
Vector Pixel to
be input via web
GUI.
File name of the
spectrometer
calibration
matrix to be
loaded