OPERATION
TRANSPORTATION
3-133
Increasing Track Gauge
1. Remove center frame mounting bolts (2) (one side, front +
rear: 8 bolts) from the front and rear of the track frame on the
side to be extended.
2. Swing the upper structure so that it is at 90
°
on the opposite
side to track frame (A) to be extended.
REMARK
Height H of the track frame being raised should be less than 50
mm (2 in). Take care not to raise the track frame so much that the
stopper bolt is distorted.
3. Using the arm, pull the machine to the front.
The track frame will slide.
4. Extend the track frame until it comes into contact with the
stopper, then lower the machine slowly to the ground. Install
bolts (1) (one side, front + rear: 16 bolts) and tighten to speci-
fied torque.
5. Tightening torque: 1960 - 2450 N
·
m
(200 - 250 kgf
·
m, 1450 - 1810 lbft)
6. Follow the same procedure to retract the track frame on the
other side.
q
Stop the machine on firm level ground when extending or
retracting the track frame gauge width.
q
Never operate the cylinders suddenly when extending or
retracting the track frame gauge width. It is dangerous if
they are operated suddenly.
Summary of Contents for PC600-7
