TRANSPORTATION
OPERATION
3-132
PROCEDURE FOR INCREASING OR REDUCING TRACK FRAME GAUGE
3
WARNING
Never use the machine for operations with the track frame retracted.
Reducing Track Gauge
1. Remove center frame mounting bolts (1). (one side, front +
rear: 16 bolts)
2. Swing the upper structure so that it is at 90
°
on the side of
track frame (A) to be retracted, then use the work equipment
to jack up the track frame.
3. Set blocks (B) (20 to 30 cm (8 to 12 in) wooden blocks)
towards the outside of track frame (A), then use the boom cyl-
inder to lower the machine slowly. The track frame (A) will
slide and stop when it contacts the stopper.
4. Lower the machine carefully and install bolts (2). (one side,
front + rear: 8 bolts out of bolts (1))
5. Tightening torque: 1960 - 2450 N
·
m
(200 - 250 kgf
·
m, 1450 - 1810 lbft)
6. Follow the same procedure to retract the track frame on the
other side.
Summary of Contents for PC600-7
