35
GalStar
Instruction 1.0
4. Advanced Operation
o
Under/Over Fl. Delay Reaction (Idle, Alarm, Fault):
The three options allow: no
reaction, issue an alarm but continue normal operation or issue an alarm and stop irrigation.
•
Program Conditions:
Shows the number of logic condition applied to the program.
Sequence Status (124):
See “Basic Operation”. Most of the parameters shown here are similar
to “Program Information”.
Sequence Data (1241):
Press “Sequence Data” in the “Sequence Status – 124” screen.
Screen Explanation:
Shows a table of the programs assigned to the sequence. Each row
represents one program with the following properties (columns):
•
Program Number:
•
Program Status:
The options are:
None, Num
– the number of the program is out of range
, Def
– the program has a definition error
, Off, Fin, N.F
(not finished) – the program has not finished its
amount of water but stops operating due to a fault. It will continue irrigating after the current stage of
the sequence finishes.
, Fail, Wait, Irr., Fert, Irr, Fert -
the last 2 parameters appear in red in the
PC software which means that there is an alarm – most of these parameters are the same as the
program status (see “Irrigation Programs”).
Sequence Programming (1242):
See “Basic Operation”.
Sequence Constants (1243):
See “Basic Operation”.
