Fujitsu PRIMERGY RX350 S8, Upgrade And Maintenance Manual

Page: 380 / 792

380 Upgrade and Maintenance Manual
TX300 S8 / RX350 S8
Expansion cards and backup units
9.3.3.4 Concluding steps
Ê
"Installing the system air duct" on page 83
Ê
"Closing the server" on page 98
Ê
When working on a rack-mounted server:
"Mounting the server in the rack" on page 115
Ê
Reconnect all external cables to the replaced expansion card.
Ê
"Connecting the server to the mains" on page 118
Ê
Enable the PCI slot of the replaced expansion card as described in section
"Enabling replaced components in the system BIOS" on page 147 .
Ê
Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
"Looking up changed MAC / WWN addresses"
on page 153 .
Ê
After replacing a network controller in a server running Linux OS, update its
MAC address in the related NIC definition file as described in section
"Updating the NIC configuration file in a Linux environment" on page 150 .
Ê
"Enabling SVOM boot watchdog functionality" on page 146
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task:
"Resuming BitLocker functionality" on page 152
Ê
Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section "Note on network
settings recovery" on page 378 .
Ê
If applicable, restore LAN teaming configurations as described in section
"After replacing / upgrading LAN controllers" on page 157 .