Fujitsu Primepower200, User Manual

Page: 237 / 272

11.5 8mm Tape Drive
tape-config-list =
"EXABYTE EXB-8505", "Exabyte 8mm EXB-8505", "EXBT-8SC";
EXBT-8SC = 1,0x35,0,0xce39,2,0x15,0x8c,1;
IMPORTANT
If another tape-config-list has already been defined, use a "," as a separator and add the new lines
the file as shown in the following example.
Tape-config-list =
"HP C1537A", "HP DDS3 4mm DAT", "HP_data2",
"EXABYTE EXB-8505", "Exabyte 8mm EXB-8505", "EXBT-8SC";
HP_data2 = 1,0x34,1024,0xd639,4,0x00,0x13,0x24,0x3,3;
EXBT-8SC = 1,0x35,0,0xce39,2,0x15,0x8c,1;
3
Shut the system down:
# shutdown -y i0
4
Then reboot the system, using the -r flag
ok boot -r
Table 11.8 shows the data formats supported by this unit.
Table 11.8 Supported Data Formats (8mm Tape Drive)
Data Format Read Write Note
EXB-8200
EXB-8500
EXB-8200c
EXB-8500c
No
Yes
No
Yes
Yes
Yes
No
Yes
Write protect tab must be set ("read only")
When specifying the data format to be used by your 8mm tape unit, refer to the density codes in Table 11.9 :
Table 11.9 Density Codes When Specifying Data Formats
Data Format Density Code Special File ( * )
/dev/rmt/ x l[n]
/dev/rmt/ x m[n]
/dev/rmt/ x c[n]
0x14 (14h)
0x15 (15h)
0x8c (8ch)
EXB-8200
EXB-8500
EXB-8500c
(*): A number, such as 0, will need to be specified at x in this column (the actual number will vary from
system to system). [n] stands for no rewind.
209