Fujitsu Primepower200, User Manual

Page: 9 / 272

CAUTION
This indicates a hazardous situation that could result in minor or moderate
personal injury if the user does not perform the procedure correctly. Also,
damage to the product or other property may occur.
Normal Operation Cautions
Task
Data destruction:
Data destruction:
Data destruction:
Data destruction:
Data destruction:
Data destruction:
Data destruction:
Data destruction:
Unit damage/
Data destruction:
Unit damage:
Pressing the RESET switch while the system is running may
cause data to be lost.
Caution
Install "Enhanced Support Facility" before operating the system.
Without this package, incorrect front panel operations and
hardware errors may cause the system to shutdown or cause data
to be lost.
Pressing the REQUEST switch while the system is running
may cause data to be lost.
Do not turn the console (unit connected to serial port) on
after turning the PRIMEPOWER on, or turn the console off while
the PRIMEPOWER is on. Doing so might cause system
malfunction and cause data to be lost.
Before turning the power off, check the following points.
Otherwise, data may be lost.
Are there any currently executing programs?
Are there any current users?
Are floppy disks or tape cartridges still inserted in
their drives?
If necessary, back up files before turning the power off.
If improper commands are used at the ok prompt, data may be
lost. If you need to use any other commands except those given
in this manual, you should fully understand the function and usage
of the command before using it.
Except in any emergency, never turn the AC main line switch or
disconnect the power cable while the PRIMEPOWER is turned on.
If you do, data in the disk drive may be lost.
Before you eject a floppy disk, be sure to either execute
the Solaris eject command, or perform eject operation in the
application you are using. Failure to do so might cause data to be
lost. Also, do not eject a floppy disk while the access
LED is on. Doing so may damage the disk.
Pay attention to the following points when handling the
hard disk units. If these precautions are not observed,
the magnetic disk unit may be damaged or data lost.
Do not subject the unit to exceeds impact.
Do not bring the unit near to equipment (motors,
speakers, etc.) that generate strong magnetic fields.
Do not store the unit at locations likely to cause
condensation inside the unit or at locations subject to
sudden changes in temperature or humidity.
Do not connect I/O units to the maintenance port.
Connecting I/Os to the SCF port may damage this unit.
vii