Fujitsu Primepower200, User Manual

Page: 207 / 272

10.2 Names and Functions of Parts
(1) POWER LED
The POWER LED indicates that power to the Expansion File Unit Type-2 is on.
(2) CHECK LED
The CHECK LED when an error occurs in the Expansion File Unit Type-2, as shown in Table 10.1 .
Table 10.1 CHECK LED
LED Description
Dark Normal
Blinking Response to
maintenance command
Lit Error detected
Blinks in response to server unit
maintenance /repair procedures
(allowing confirmation or the unit to
be repaired).
Lights when a power supply unit or fan
malfunctions.
Status
10.2.2 Rear side
The names and functions of parts on the rear side of the Expansion File Unit Type-2 are as follows.
(1) SCSI OUT
(1) SCSI IN
(2) RCI Connector
Base SCSI Unit File Unit Expansion Kit (option) or
Expansion Tape Unit (option)
Figure 10.2 Rear of Expansion File Unit Type-2
(1) SCSI connectors
The Expansion File Unit Type-2 is equipped with two built-in SCSI connectors, one for the base
SCSI bus and the other for the expansion SCSI bus.
In the base configuration, connect the SCSI cable only to the SCSI IN (base) connector and connect
the terminator plug to the SCSI OUT (base) connector.
If the File Unit Expansion Kit is installed, connect the SCSI cable to the SCSI IN (expansion)
connector and connect the terminator plug to the SCSI OUT (expansion) connector.
All of the Expansion File Unit Type-2 SCSI connectors are VHDCI type.
(2) RCI connector
Use the RCI cable provided with the Expansion File Unit Type-2 to connect it to the
PRIMEPOWER Server. The RCI splitter/connector should be used to attach the RCI cable.
A terminator must also be connected.
The appropriate RCI commands must be issued to add/set-up an Expansion Disk File Unit Type-2.
179