Fujitsu Primepower200, User Manual

Page: 245 / 272

11.6 DLT Tape Drive
LED / Button Name
2.6 LED
6.0 LED
10.0/15.0 LED
Description
(Not currently used)
Record density of the loaded tape.
State (Color)
(Dark)
Lit (Amber)
Recording density to be used to write data
(if different from the current format). Blinking (Amber)
20.0 LED
35.0 LED
Compression mode is active. Compress LED
Lit (Amber)
Compression mode is inactive
(data will be written non-compressed). Dark
Data will be written using the recording
density specified by the Select Button.
Select Button is being used to set the
recording density.
Data will be written using the recording
density specified by the host software.
Lit (Amber)
Blinking (Amber)
Dark
Density Override
LED
Use to manually set the compression
mode (compressed/non-compressed)
and recording density (20.0/35.0). --- Select Button
Lit (Orange)
Dark
Write Protect LED
Loaded tape is set to "read only".
Loaded tape may be written to.
Lit (Amber)
Blinking (Amber)
Dark
Tape in Use LED Tape is loaded (and idle) in the drive unit.
Tape is moving or drive unit is performing
diagnostics.
No tape is currently loaded.
Use Cleaning Tape
LED Tape heads require cleaning. Lit (Amber)
Operate Handle
LED Cartridge handle can be used to eject the
loaded tape.
Cartridge handle cannot be currently
operated.
Lit (Green)
Dark
Unload Button Pressing readies the loaded tape for
ejection. ---
POST diagnostics are running. Lit
Fault detected. Blinking
All 7 Left-hand
LEDs or
All 4 Right-hand
LEDs
Note
Set using the Select Button.
(See example below)
Set using the Select Button.
Set using the Select Button.
If lit, the settings of the host
software will be ignored.
For details, see ⁄9.6.9
"Cleaning the tape heads".
For details, see ⁄9.6.8
"Ejecting a data cartridge".
If reboot does not clear
fault, contact a CE for help.
(See example below)
(Example)
When the loaded tape has previously been recorded at 20.0GB, if the Select Button is used to set the recording
density to 35.5 GB, and new data is recorded on the tape, then the Indicator LEDs will change as follows:
Before recording: 20.0 LED = Lit 35.5 LED = Blinking Density Override LED = Lit
After recording: 20.0 LED = Dark 35.5 LED = Lit Density Override LED = Lit
11.6.2 SCSI ID
Set the SCSI ID of the DLT tape drive to "5".
217