Fujitsu Primepower200, User Manual

Page: 236 / 272

CHAPTER 11 Internal I/O Units
Table 11.7 8mm Tape Unit LED States
Warning
LED
Lit
Fast Blink
Dark
Dark
Dark
Dark
Lit
Slow Blink
Fast Blink
Dark
Access
LED
Lit
(any)
(any)
(any)
(any)
(any)
Lit
(any)
(any)
(any)
Tape Drive Status
Performing start-up diagnostics
Diagnostic error has occurred
Data cartridge is not loaded
Data cartridge is loaded and idle
Loading or running tape (normal speed)
Loading/unloading or running tape (high speed)
SCSI bus is being reset
Drive has malfunctioned
Tape heads require cleaning
Tape heads being cleaned
Ready
LED
Lit
Dark
Dark
Lit
Slow Blink
Fast Blink
Lit
Dark
Fast Blink
Slow Blink
(4) Eject Button
Press the Eject button to remove the data cartridge. Before removing a data cartridge, make sure
that the Tape LED is out.
If the 8mm Tape software has disabled removal of a data cartridge, the cartridge cannot be removed
by pressing the Eject button.
(5) Data Cartridge Slot
CAUTION
Never insert your fingers or other foreign objects in the data
cartridge slot, as this may damage the unit or cause data to be lost.
11.5.2 SCSI ID
Set the SCSI ID of the 8mm tape drive to "5" if it is the 1st drive in the PRIMEPOWER or the Expansion File Unit
Type-2. Set the SCSI ID to "3" if it is the 2nd drive.
11.5.3 OS settings
Before using a 8mm tape drive, the /kernel/drv/st.conf file must be modified, as follows:
1
Copy as original st.conf file:
# cp /kernel/drv/st.conf /kernel/drv/st.conf.old
2
Add the following lines to the /kernetl/drv/st.conf file:
208