Fujitsu M10 Series, Product Notes

Page: 32 / 216

initialized.
When executing the restoredefaults(8) command, save the CPU Activation key in
advance before restoring it or register the key again.
In addition, when you replace a CPU memory unit or motherboard, the CPU
Activation key may be erased. For details, see " Notes on maintenance for CPU
memory units, motherboard unit, XSCF unit, PSU backplane, or crossbar
backplane unit ."
■
If you execute the restoredefaults -c xscf command on XCP 2041 or later, the
information of the CPU Activation key is deleted not only from the XSCF unit but
also from the backup information in the XSCF. On the other hand, even if you
execute the restoredefaults -c factory command, the information of the CPU
Activation key is not deleted.
To initialize all settings to factory defaults including the information of the CPU
Activation key, use the -c factory -r activation option.
■
XSCF setting information saved by the dumpconfig(8) command contains CPU
Activation information and CPU Activation keys.
You can use the restoreconfig(8) command to restore the CPU Activation
information and CPU Activation keys that were saved with the dumpconfig(8)
command.
Therefore,
if you configure CPU Activation or install a CPU Activation key when
configuring settings for the XSCF, such as when configuring an XSCF network or
physical partition (PPAR), we recommend that you first save the CPU Activation
information and CPU Activation key by using the dumpconfig(8) command. To
save and restore only CPU Activation keys, execute the dumpcodactivation(8) and
restorecodactivation(8) commands, respectively. Note, however, that CPU
Activation information cannot be saved and restored. Use the showcod(8) and
setcod(8) commands to reconfigure CPU Activation.
Notes and restrictions on XSCF Web
Notes
(1)
Common to browsers
■
When you import XCP or update the firmware by using XSCF Web, "Session is
invalid" may appear on the web browser.
■
If the timeout of the XSCF shell is short when you import XCP by using XSCF
Web, XCP importing fails. Set the timeout of the XSCF shell to 30 minutes or
longer.
Select the [menu] tab and select [XSCF] - [Settings] - [Autologout] menu. Then,
enter a value of 30 minutes or greater in [Time-out value].
(2)
Internet Explorer
If you use XSCF Web of a version XCP 2221 or earlier while you are in Internet
Explorer 10 or 11, you may see distorted screen layouts, such as disordered
tables or superposed characters. If you see a distorted XSCF Web screen layout
in the above environment, use Internet Explorer 9 or earlier or Firefox.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015 18