Fujitsu M10 Series, Product Notes

Page: 160 / 216

Table 3-21 Problems resolved in versions prior to XCP 2050 (continued)
SPARC M10-
RTI No. 1 4 4S Description Workaround
RTIF2-
121113-009
x x x While XSCF is running, process down,
panic or watchdog timeout occurs, which
may cause XSCF not to be restarted after
XSCF reset.
Confirm that XSCF is successfully started.
If it is not started, turn off the power of
the physical partition (PPAR), and then
disconnect the input power supply to the
system and back on again (AC OFF/ON).
When recycling the power supply to the
system, wait for 30 seconds or more to
turn on the input power supply after
disconnecting.
In case XSCF is not started even if
recycling the input power supply to the
system, replace the CPU memory unit
lower (CMUL) or the motherboard unit
(MBU).
RTIF2-
121113-011
x x x If you execute the showsnmp(8)
command, the following message may
appear, which means that the snmp
daemon has been terminated.
Agent Status: Disabled
Execute the showsnmp(8) command
again to confirm that the snmp daemon
is restarted.
If "Agent Status: Disabled" remains
displayed, execute the setsnmp enable
command to restart the snmp daemon.
RTIF2-
121113-014
x x x The error message "/etc/redhat-release
not found" appears while XSCF is starting.
Ignore this message.
RTIF2-
121113-018
x x x When you replace an FRU with the
replacefru(8) command, the message
"configuration changed (...)" showing the
configuration change may be registered
more than once in the event log.
Ignore the message that appears second
time and later.
RTIF2-
121113-019
x x x When the power supply of the physical
partition (PPAR) is disconnected
according to the power supply schedule,
"-" may be displayed as the cause (Cause)
in the power log.
There is no effective workaround.
RTIF2-
121113-021
x x x If time cannot be read accurately due to a
failed clock in the XSCF board, an error
showing a clock failure may not be
recorded in the error log.
There is no effective workaround.
If the following message appears when
you execute the poweron(8) command,
the clock in the XSCF board has failed.
Replace the XSCF board.
Poweron canceled due to invalid system
date and time.
RTIF2-
121113-022
x x x If the operation panel has failed or is not
connected, XSCF cannot be started.
Connect the operation panel. If the
operation panel has failed, replace it.
RTIF2-
121113-023
RTIF2-
121113-028
x x x If a CPU failure occurs while Hypervisor
is running, the physical partition (PPAR)
is reset more than once, and restarting of
the PPAR may take time.
There is no effective workaround.
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015 146