Fujitsu M10 Series, Product Notes

Page: 106 / 216

Table 3-9 Problems resolved in XCP 2230 (continued)
SPARC M10-
RTINo. 1 4 4S Description Workaround
RTIF2-
140606-007
x Suppose that the system is made up of
multiple physical partitions (PPARs)
consisting of multiple SPARC M10-4S
chassis. If you turn on the power to
multiple PPARs at the same time, for the
first time after turning on the input
power or resetting the XSCF, the
following event may occur: A PPAR ID
error is registered, the self-diagnosis test
(POST) on some PPARs is not completed,
and these PPARs fail to start.
You can confirm this event by executing
the showpparstatus command.
[Example] Only PPAR #4 is indicated
with "Initialization Phase" and fails to
complete POST processing.
XSCF>
poweron -a
XSCF>
showpparstatus -a
PPAR-ID PPAR Status
00 Initialization Complete
01 -
02 -
03 -
04 Initialization Phase
05 -
06 Initialization Complete
07 -
08 -
09 -
10 -
11 Initialization Complete
12 -
13 -
14 -
15 -
XSCF>
Do not use the poweron -a command to
turn on the power to multiple PPARs at
the same time. Use the poweron -p
command to turn on the power to PPARs
one at a time.
[How to restore]
Turn off the power to PPARs by using
the following procedure and then turn it
on again:
1. Execute the poweroff -f command to
forcibly turn off the power to the
PPARs that have failed to start.
XSCF>
poweroff -y -f -p
ppar_id
2. Confirm that the status of each PPAR
specified in step 1 is "Powered OFF".
XSCF>
showpparstatus -p
ppar_id
--- Omitted ---
04 Powered Off
--- Omitted ---
3. Turn on the power to the PPAR again.
XSCF>
poweron -y -p
ppar_id
RTIF2-
140623-002
x x x If you specify "pop" as the authentication
method by executing the setsmtp(8)
command, e-mail sending may fail even
after you execute the setemailreport(8)
command to enable e-mail notification.
When executing the setsmtp(8) command
to specify an authentication method,
specify either "smtp-auth" or "none"
instead of "pop".
Fujitsu M10/SPARC M10 Systems Product Notes for XCP Version 2240
･
March 2015 92