Fujikura FSM-20PMII, Instruction Manual

Page: 67 / 93

-66-
WARNING WARNING WARNING WARNING
During arc discharge, the electrodes generate very high voltage. The
following prevents form personal injury and/or equipment damage
caused by the high electrical voltage.
-Make sure no water or liquid is present on the equipment.
-Never touch the electrodes.
-Before operation, connect the equipment to the electrical ground
(earth).
-When using an AC power source, use the AC power cord attached. It
connects to electrical ground through the third pin of the AC plug.
-Make sure the power switch is off when the power cord is plugged in
or out.
-Turn the power switch off and disconnect the power cord before the
electrodes, the fuse or the up/down mirror is replaced.
Dangerous electrical voltages are present inside this equipment.
Failure to maintain the equipment properly may result in personal
injury and/or equipment damage.
CAUTION CAUTION CAUTION CAUTION
Set the electrodes into the correct position during replacement.
Failure to place the new electrodes into the proper position may
results in abnormal discharge, and damage to the equipment.
Always replace the electrodes as a pair.
Use only alcohol to clean the objective lens, mirrors, v-groove, sheath
clamp, fiber clamp, LCD monitor and body. Any other chemicals may
cause blurring, discoloration or deterioration.
Keep the equipment free from sand or dust. Never clean the v-groove
with a hard material or rough object. Doing so will damage the
surface, and degrade the performance.
Precise adjustment and alignments have been made to all parts of this
equipment before shipping. Do not loosen any screws or make any
modifications to the equipment other than electrodes, up/down mirror
and fuse replacements. If you encounter some problem with the
equipment, please contact a sales agency.