Fujikura FSM-20PMII, Instruction Manual

Page: 13 / 93

-12-
34 Motor Indicator The lamps of the indicator display the selected motor
by the motor by the "Motor select" key.
35 MODE Key To change the splice mode to P1, P2, P3, SM or MM.
The mode indicator displays the splice mode according
to this key.
36 X / Y Changes the focus from the X view to the Y view, or the
Y view to the X view. If this is done after a gap set
operation, the fiber are adjusted to the center of the
monitor and focused automatically.
37 RESET Key Used for the reset operation. When RESET key is
pressed, the system stop at any step of operation and
the fibers move back to Z-axis home position. Splicer
performs the RESET with a beep sound and displays
"RESET" during the reset operation. After the reset
operation is completed, "READY" is displayed on the
monitor.
38 ARC Performs the arc discharge when "READY," "PAUSE"
(after gap setting) and "FINISHED" (after splicing)
messages are displayed on the screen. In the "PAUSE"
state, the splicer performs the arc discharge as well as
the fiber stuffing when the "ARC" key is pressed. If the
splice mode is SM, the loss estimation automatically
follows the discharge operation. Only the arc discharge
occurs if the "ARC" key is pressed in the "READY"
state. In the "FINISHED" state, pressing the "ARC"
key results in the rearc.
39 SET To start the splicing operation, or to go through to the
"PAUSE" state.
40 Motor Direction Key During manual motor control, these arrows serve as
the "Backward" and "Forward" keys to operate the
motors.
41 Condition Input key Used for entering numeral to parameters.
42 DC IN Power
terminal
Used to connect the control cord from the DC OUT
Power terminal of the splicer main body to the control
box.
43 SER. PORT
Terminal
Used to connect the control cord from the SER. PORT
terminal of the splicer main body to the control box.
44 DC Fuse Holder The DC 0.5A fuse is used.
45 Power Switch Used to turn on and off the control box.