Fujikura FSM-20PMII, Instruction Manual

Page: 27 / 93

-26-
(2) The splicer begins high voltage ARC
fusion, and stuffs the left fiber towards
the right fiber. (Display 5)
[NOTE] The ARC POWER is automatically
compensated for atmospheric
pressure.
(3) "FINISHED" message is displayed on
the monitor (Display 6).
5. Observe the splice point visually
Observe the splice point visually. The splicer cannot always detect every splice
defect. If any of the following problems as shown in figure are present, take
the appropriate measure by referring to the table below.
Table : Treatment of Defective Spliced Results
PROBLEM CAUSE MEASURE
Bad fiber end
Chipping the edge of
fiber end
Prepare the fiber end again or check the fiber
cleaver.
Dust on the fiber end Prepare the fiber end again.
Bubble
Short prefuse time Adjust the prefuse time. Refer to section 5.1.
Lack of stuff amount Carry out the ‘STUFF CHECK’ command to
check it. Refer to section 5.1.1 and 6.2.3.
Strong ARC POWER Reduce the ARC POWER. Refer to section 5.1.1.
Separation
Long prefuse time Adjust the ARC POWER. Refer to section 5.1.1.
Lack of stuff amount Carry out the ‘STUFF CHECK’ command to
check it. Refer to section 5.1.1 and 6.2.3.
Too thin
Strong ARC POWER Reduce the ARC POWER. Refer to section 5.1.1.
Too fat Large stuff amount Carry out the ‘STUFF CHECK’ command to
check it. Refer to section 5.1.1 and 6.2.3.
P1-PP
FINI SHED ( X)
Display 6
Bubble Separation Too thin
Too fat