Fujikura FSM-20PMII, Instruction Manual

Page: 26 / 93

-25-
[NOTE] Observe and check the fiber ends on the monitor with your eyes. In
case the fiber ends are bad as shown in figure below, press the
"RESET" key to cancel the splice. Then prepare the fiber ends again,
i.e., stripping, cleaning and cleaving.
[NOTE] The splicer may not detect the dust on the fiber surface sometimes. If
there is visible dust, press the "RESET" key to cancel the splice, then
prepare the fiber ends again, i.e., stripping, cleaning and cleaving. The
dust may cause high splice loss.
[NOTE] When the "RESET" key is pressed during splice process, the fiber
image of next splice may not correctly focused or positioned on the
monitor. In such case, please make Focus or Field motors move with
control box.
3. Automatic Alignment (Core, Clad, or
θ
axis)
Press "SET" key to start splice process again
when the splicer is PAUSE state ("PAUSE1").
Alignment procedures of splice modes are
different. See Section 4.3.
[NOTE] Fiber image seems different by each
fiber type or alignment procedures.
Specially Tiger fiber image during
θ
axis alignment seems out of focus.
4. Arc Fusion Splicing
Press "SET" key to start splice process again
when the splicer is PAUSE state ("PAUSE2").
(1) Both fibers move toward each other
again. The splicer sets a narrow gap
between the fiber ends. The width of the
narrow gap is the same as the "GAP"
value of the "CONDITION SET." menu
(Display 4).
Crack Lip Incline
P1-PP
## ARC ## 15 (Y )
Display 4
P1-PP
## ARC ## 15 (Y )
Display 5