Fujikura FSM-20PMII, Instruction Manual

Page: 20 / 93

-19-
4.2 Splicing procedure
4.2 Splicing procedure 4.2 Splicing procedure
4.2 Splicing procedure
4.2.1 Connecting of Power Cord
1. Confirm that the Power Switch is OFF
Confirm the power switch is OFF before connecting the AC Power Cord.
2. Connecting the AC Power Cord
Plug the AC power cord into the AC power terminal.
Connect DC OUT power terminal of the splicer and DC IN power terminal of
the control box with DC power cord.
Connect SER.PORT terminal of the splicer and SER.PORT terminal of the
control box with control Cord.
4.2.2 Power ON/OFF Procedure
4.2.2.1 Power ON Method
1. Remove the blue Z-unit stopper
Remove the blue Z-unit stopper form the splicer.
2. Check Input Voltage
Input voltage must be AC100-240V 50-60Hz (Max.3A.). Check the voltage
fluctuation and the power factor when an AC power generator supplies AC
power to the splicer.
3. Turn ON the Power Switch of the splicer
Turn ON the power switch of the splicer.
4. Check the Input Voltage Indicator and message of the monitor
(1) Input Voltage Indicator
A needle of the voltage indicator
should point to the green range in
the AC power.
(2) Message of the Monitor
"READY" message appears after a
self-diagnostic test. (Display 1)
5. Turn ON the Power Switch of the Control Box
Turn ON the power switch of the Control Box.
The LED lump on the Control Box lit up and indicate splice mode and
selected motor.
P1
READY (X )
Display 1
X Y ZL ZR PL PR FOC FIL MIR P1 P2 P3 SM MM