OPERATING
RECOMMENDATIONS
for MODEL OD
READ THOROUGHLY AND UNDERSTAND
THIS PUBLICATION BEFORE ATTEMPT-
ING TO OPERATE THE EQUIPMENT.
DANGER!
The application of this prod-
uct requires an exposed rotating tool
holder and cutting blade.
It produces
HOT, SHARP metal fragments requiring
P.O. Box 393
Wadsworth, OH 44281, U.S.A.
(330) 336-4550/(330) 335-1536
Fax: (330) 336-9159
e-mail: [email protected]
Web site: www.H-STOOL.com
Tool
Holders
Feed
Knob
Throttle
T-Handle
Wrench
Allen Wrench
Locator Block
Locking
Nut
Locking
Wrench
Hose
Swivel
COMPONENT DESCRIPTION
that eye, ear, and hand protection and
other protective clothing be worn at all
times. Do not wear loose fitting clothing
that may become entangled with the ro-
tating objects. Only work on properly in-
stalled scaffolding or other approved
work platforms, with approved safety
belts, in elevated areas.
Tool Holder & Blades
Select the proper size tool holder for your appli-
cation. The larger holder is generally installed on
the machine at the factory unless otherwise
specified. This covers the full range of the Model
OD. The smaller holder is used in areas where
the 2-1/4" (57.2 mm) holder is too large to fit
between tubes.
The tool holder has an allen head setscrew and
key. Installing the holder requires that the key be
placed in the slot of the shaft and the holder slid
on to the shaft, over the key, until it bottoms out.
The set screw is then tightened securely.
Select the appropriate cutting blade. Loosen the
small allen head setscrew with the allen wrench
provided. The base of the blade slides in from
the side (machined cutting edge facing the
direction of rotation) and positioned to reach
past the outside of the tube to be milled. The
setscrew is then tightened securely.
