Fujikura FSM-20PMII, Instruction Manual

Page: 30 / 93

-29-
4.3 Alignment process of each splice mode
4.3 Alignment process of each splice mode 4.3 Alignment process of each splice mode
4.3 Alignment process of each splice mode
4.3.1 P1-
∗∗
mode (P1-PP, P1-PT, P1-TP, P1-TT)
Both XY-axis alignment and
θ
axis alignment are performed by PAS in the case
of P1
‑
∗∗
mode. (PAS: Profile Alignment System)
1. Splice Mode Selection
(1) Ensure the splicer is "READY" state.
(2) Select splice mode by pressing "MODE"
key on the control box. Ensure that splice
mode is suitable for the fiber type.
(Display 1)
2. Fiber Setting
See the section 4.2.5.
Ensure that both left and right fibers are
suitable for the splice mode.
3. Press the "SET" key
The splicer operates cleaning ARC, initial
gap setting and cleave angle check. "CHECK
FIBER" message is displayed if "PAUSE1" is
"ON" in the "OPTION SET." menu.
(Display 2)
[NOTE] The Cladding axial offset value is
displayed if "DATA" is "ON" in the
"OPTION SET." menu. Refer to Section
5.2.
4. Automatic Splicing Procedure
(1) Press the "SET" key to start splice process
again if the splicer in PAUSE state
("PAUSE1").
(2) The splicer aligns the cladding in both X
and Y fields, and displays "XY
ALIGNING" massage.
(3) The splicer aligns
θ
axis, and displays
"PM ALIGNING" massage. The splicer
beeps 3 times after
θ
axis alignment is
finished, and will be in a PAUSE state if
“PAUSE2” is ON.
∗ P1-PP P2- PP
P1-PT P2-PT
P1-TP P2 -TP
P1-TT P2-TT
P3
SM
MM
READY (X )
Display 1
P1-PP
225
0.7 0.2
CHECK FIBER (X)
Display 2
P1-PP
XY ALIGNING (Y )
Display 3