Fujikura FSM-20PMII, Instruction Manual

Page: 25 / 93

-24-
4.2.6 Automatic Splicing Procedure
The automatic splice procedure is described as below.
1. Confirmation of the "READY" message
Check "READY" message is displayed on
the monitor (Display 1). Press the
"RESET" key to enter the "READY" state
if the "READY" message is not displayed.
2. Initial Gap Setting, Cleaning Arc and
Cleave Angle Check
Press the "SET" key to start splicing
process.
(1) Starting the Initial Gap Setting
At first, the splicer move forward.
(Display 2).
(2) Cleaning Arc
During the fiber forward motion, a
short Arc occurs to clean the fiber
surface.
(3) Initial Gap Setting
The proper gap between fiber ends is
set.
(4) Cleave Angle Check
After the gap setting, the cleave
angle is measured and displayed on
the monitor. (Display 3)
[NOTE] The splicer will be in a PAUSE state after gap setting if "PAUSE1" is
"ON" in the "CONDITION SET." menu. In the pause state. "CHECK
FIBER" message appears on the monitor. (Display 3)
(Concerning "PAUSE1" function, see Section 5.2.)
P1-PP
READY (X )
Display 1
P1-PP
225
0.7 0.2
CHECK FIBER (X)
Display 3
P1-PP
GAP SETTING (X )
Display 2