77
Using the printer connected to a PC
6
Using
the
printer
connected
to
a
PC
INSTALLATION PROBLEMS-Macintosh
■
When the printer was connected to the Macintosh, the “Required software was
not found” message or “Required driver cannot be used” message appears.
Check
Solution
Install the software (
→
P.68).
Is the software installed?
PRINTER PROBLEMS-Macintosh
Check
Solution
■
Pictures cannot be printed from FinePixViewer.
Install the printer driver (
→
P.68).
Is the printer driver installed?
Check if one end of the USB cable is
connected to the printer and the other end is
connected to the Macintosh.
Are the printer and Macintosh connected by
a USB cable?
Select CX-550 as the printer.
Is a printer selected?
Is the CX-550 selected in the Chooser?
Set “CX550”, “CX-550Monitor”, “FTLUSB
_Lib”, and “FTLUSB_Drv_04CB5000” in
Extensions Manager to Enable and restart
the Macintosh.
Is the printer driver enabled?
Solution
■
I want to print pictures from an application other than FinePixViewer.
Select “File”
→
“Print” from the menu. The dialog box that is displayed here varies
depending on the application. The setting items and printed result are also different. For
more information, refer to the application manual.
If the printer is connected as a card reader,
switch to printer connection (
→
P.80).
Is the “CONNECTED TO PC IN PRINTER
MODE” message displayed on the printer
screen?
Was the “P104: Connection to the printer is
failed” error message displayed?
Close the Chooser and switch the printer off
and then on again. Then select the CX-550
in the Chooser and try printing again.
When I tried to launch FinePixVeiwer, the “Quick
Time Lib could not be found” message appeared.
76
Using the printer connected to a PC
6
TROUBLESHOOTING TABLE-Macintosh
If the software does not operate correctly, check that you are using the correct hardware and
software.
If the problem persists even though you are using the correct hardware and software, refer to the
table below and then see the reference page listed for your problem.
Type
Problem
Page
Installation problems
77
78
78
79
78
77
77
Printer problems
Pictures cannot be printed from FinePixViewer.
Application problems
I want to stop FinePixViewer from launching
automatically.
Memory card problems
The printer is connected to the Macintosh, but the
“Removable disk” icon is not displayed.
FinePixViewer does not recognize the memory card.
Mac OS “Initialize disk” message was displayed.
A warning message appears when the memory card
was removed or the USB cable was disconnected
from the printer.
79
79
79
The Macintosh hangs when the memory card is
accessed.
When the printer was connected to the Macintosh,
the “Required software was not found” message or
“Required driver cannot be used” message appears.
I want to print pictures from an application other than
FinePixViewer.
I want to quit Exif Launcher.
79
Macintosh hardware and software requirements
Compatible models
Power Macintosh G3, PowerBook G3,
Power Macintosh G4, iMac, iBook,
Power Macintosh Cube, PowerBook G4
Operating System
Mac OS 8.6 to 9.2
RAM
64MB to minimum
Hard disk space
Amount required for installation 70MB minimum
Amount required for operation 300MB minimum
Display
800
×
600 pixels or better, approx. 32,000 colors
Internet connection
Transmission speed 56 kbps minimum (recommended)
modem connection.
