Fuji Xerox DocuCentre S2220, User Manual

Page: 197 / 311

System Settings
197
Tools
9
System Settings
Used to make other settings.
For information on how to display the [System Settings] screen, refer to "System Settings Procedure" (P.162).
Power Saver Timer
Used to make settings for the Energy Saver function.
Low Power Mode
Sets the amount of time the machine waits before entering Low Power mode.
You can set a value between 1 and 60 minutes (in 1 minute increments).
The machine's power is not turned OFF completely in Low Power mode. Instead, this mode
creates a balance between low power consumption and short warm-up time by controlling
the temperature of the fusing unit to a level midway between the power OFF temperature
and the "Ready" temperature.
[1 minute] is set at the time of factory shipment.
Sleep Mode
Used to set the amount of time the machine waits before entering Low Power mode or Sleep
mode.
You can set a value between 1 and 239 minutes (in 1 minute increments).
Sleep mode minimizes power consumption by shutting off the power to all components
except the controller. Warm-up time in Sleep mode is longer than in Low Power mode.
[1 minute] is set at the time of factory shipment.
Auto Reset
Sets the amount of time the machine waits before automatically returning to the Default
Display screen when no operation is being performed.
You can select [15 seconds], [30 seconds], [45 seconds], [1 minute], [2 minutes], [3 minutes],
or [4 minutes].
[45 seconds] is set at the time of factory shipment.
Auto Print
Used to set the amount of time the machine waits after operating the control panel, loading
paper on the document feeder, or closing a tray until starting to print automatically.
You can set a value between 1 and 240 seconds (in 1 second increments).
[10 seconds] is set at the time of factory shipment.
Idle Timeout
The amount of time to wait is set according to the operations listed below when document
is placed on the document glass and being scanned.
z The amount of time that passes to continue to the next job assuming that there is no
additional document to be loaded.