Fuji Electric frenic mini series, User Manual

Page: 161 / 269

9-4
Code Name Data setting range
Incre-
mental
unit
Unit
Change
when
running
Data
copy Default
setting
F37 Load Selection/
Auto Torque Boost/
Auto Energy Saving
Operation
0: Torque reversely proportional to the square
of speed
1: Constant torque load
2: Auto-torque boost
3: Auto-energy saving operation
(Variable torque load during acceleration
and deceleration)
4: Auto-energy saving operation
(Constant torque load during acceleration
and deceleration)
5: Auto-energy saving operation
(Auto-torque boost during acceleration
and deceleration)
— — N Y 1
F43 Current Limiter
(Operation condition)
0: Disabled
1: In constant speed
(Disabled during acceleration and
deceleration)
2: At acceleration and in constant speed
(Disabled during deceleration)
— — Y Y 0
F44
(Limiting level) 20 to 200 (The data is interpreted as the rated
output current of the inverter for 100 %.)
1 % Y Y 200
F50 Electronic Thermal
Overload Relay
(for braking resistor)
(Discharging capability)
0: (To be set for braking resistor built-in type)
1 to 900
999: (Disabled) 1 kWs Y Y 999/0
F51 (Allowable loss) 0.000: Applied for built-in braking resistor,
0.001 to 50.000
0.001 kW Y Y 0.000
Note: The default setting of function code F50 is 999 for standard models, and 0 for braking resistor built-in type.
E codes: Extension Terminal Functions
Code Name Data setting range
Incre-
mental
unit
Unit
Change
when
running
Data
copy Default
setting
E01 Terminal Command
Assignment to:[X1]
— — N Y 0
E02 [X2] — — N Y 7
E03 [X3]
To assign a negative logic input to a terminal,
set the value of 1000s shown in ( ) in the table
below to the function code.
0:
(1000) Multi-step frequency selection
(0 to 1 steps)
(SS1)
1: (1001) Multi-step frequency selection
(0 to 3 steps)
(SS2)
2: (1002) Multi-step frequency selection
(0 to 7 steps)
(SS4)
4: (1004) ACC/DEC time selection
(2 steps)
(RT1)
6: (1006) 3-wire operation stop command
(HLD)
7: (1007) Coast-to-stop command (BX)
8: (1008) Alarm reset (RST)
9: (1009) Alarm from external equipment (THR)
10: (1010) Ready for jogging (JOG)
11: (1011) Frequency command 2 or 1
(Hz2/Hz1)
19: (1019) Enable editing of function codes
from keypad (WE-KP)
20: (1020) Disable PID control (Hz/PID)
21: (1021) Switch normal/inverted driving
(IVS)
24: (1024) Select link operation
(RS485 (standard), BUS (option)) (LE)
33: (1033) Reset PID integral and differential
components (PID-RST)
34: (1034) Hold PID integral component
(PID-HLD)
— — N Y 8