Fuji Electric frenic mini series, User Manual

Page: 126 / 269

8.1 Standard Models
8-1
Chap. 8
SPECIF
ICA
T
IO
NS
8.1 Standard Models
8.1.1 Three-phase 200 V Series
*1 FUJI's 4-pole standard motor
*2 The rated capacity is for 220V output voltage.
*3 Output voltages can not exceed the power supply voltage.
*4 Use the inverter at the current given in ( ) or below when the carrier frequency setting is higher than 4
kHz ( F26 = 4 to 15 ) or the ambient temperature is 40
°
C or higher.
*5
(5.2.3)) 3 - 61800 IEC (Refer to 67
(V) voltage average phase - 3
(V) e Min.voltag - (V) e Max.voltag
(%) unbalance voltage Interphase
×
=
If this value is 2 to 3 %, use an AC reactor (ACR).
*6 Tested under the standard load condition (85% load for applicable motor rating).
*7 Calculated under FUJI-specified conditions.
*8 Indicates the value when using a DC reactor (option).
*9 Average braking torque obtained with the AVR control off. (Varies according to the efficiency of the
motor.)
*10 Average braking torque obtained by use of an external braking resistor (standard type available as
option).
Note: A box ( ) in the above table replaces A, E, or J depending on shipping destination.